Ramp profile made of aluminum and designed to avoid discon-tinuities in the pavement. The profile has a wide and smoothed visi-ble side with small grooved that favor the slide resistance. Delivered with countersunk holes to improve its fixing by using screws (not included). The inner part is reinforced to improve its load support. Available in anodized aluminum silver mat color with protective film.

Measurements:

Technical Features

• Alloy:  6063 / T5EN 755-2
• Stress test:  110-130 MPa
• Tensile strength:  160-175 MPa
• Elongation (%):  8%
• Fire resistance:  M0 (UNE 23-727-90)
• Abrasion resistance:  Very good
• Corrosion resistance:  Very good
• Appearance and color:  ExcellentEN 12373-1
• Anodizing:  Qualanod seal

Installation

This transition ramp profile is easily placed once the work is completed.

1. Clean the surface where Novonivel Access will be placed.
2. Place the profile in the desired position.
3. Remove the protective film from the surface and mark the holes that will house the fixing screws (not supplied).
4. Remove the profile and drill where you have previously marked
5. Replace the profile and fix it using the fixing screws.

Cleaning and maintenance

The product must be cleaned periodically with a soft cleaner. If you use a neutral liquid cleaner, you must rinse the profile with cold water and dry it to remove the humidity excess.

Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended. Citric acid is neither recommended because disolves the protective layer of the surface of aluminium. Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes (hydrofluoroether and chlorinated solvents) and curing accelerators containing chlorides should not be used (use special accelerators free of chlorides).