BARA-RWL - L shaped finishing profile for large format pavers

L shaped finishing profile for large format pavers, which are laid on loose gravel layers or pedestal assemblies above a waterproofing layer (in accordance with DIN 18195-5) and installed drainage layer.

The trapezoid perforated anchoring leg of Schlüter BARA-RWL is placed along the edge, on top of the waterproofing layer and adjusted to the correct height and alignment. The vertical finishing leg covers the edge of either the entire surface assembly or just the gravel layer or pedestals. Profile heights from 15 mm to 150 mm allow for any type of edge formation.

Drainage holes, spaced at approximately 7.5 cm, are incorporated at the transition of the anchoring leg and the finishing leg to ensure the correct drainage of any collecting seepage water.

Material

Schlüter BARA-RWL is available in colour coated aluminium.

Material properties and areas of application

Schlüter BARA-RWL consists of colour coated aluminium, which is roll formed from aluminium sheets.

The coating of the aluminium profile is colourfast, weather resistant and UV resistant. Visible surfaces should be protected against abrasion.

In special cases, the suitability of Schlüter BARA-RWL must be verified based on the anticipated chemical, mechanical and/or other stresses.

Installation

1. Select Schlüter BARA-RWL according to the height of the floor construction to be covered. A prefabricated corner piece is available for external corners. Abut the profile ends of Schlüter BARA-RWL, leaving a joint of approximately 5 mm. Cover the joint with the snap on connector.
2. Before the drainage mats (Schlüter TROBA or Schlüter TROBA-PLUS) are installed, set the trapezoid perforated anchoring leg of the finishing profile, Schlüter BARA-RWL, onto the waterproofing layer and, if required, adjust to the correct height and alignment with dabs of mortar.

• • a)If Schlüter BARA-RWL is used as a gravel containment profile, the gravel should reach just below the upper edge of the vertical profile leg, depending on the thickness of the covering. The gravel or crushed stone must be contained to stabilise this edge area. The next step is to install the concrete pavers loosely on the levelled gravel bed.
  • b) If Schlüter BARA-RWL is used as a finishing profile for pedestal supported coverings, the profile covers the exposed edge of the covering assembly. In this case, the exterior casting mould rings Schlüter TROBA-STELZ are installed on top of the drainage mat Schlüter TROBA-PLUS 8G in the area of the trapezoid perforated anchoring legs of Schlüter BARA-RWL. Then, install the concrete pavers over the casting mould rings.

Note: To allow for unobstructed water drainage in the edge area of the covering assembly, it must be assured that the drainage openings of the drainage membrane remain open during installation.

Maintenance

Schlüter BARA-RWL requires no special maintenance or care. The coated surface of the aluminium profile is colourfast and UV resistant. Damaged visible surfaces can be restored with paint.